Make An Angel Card With Card Embosser - Cardteq

Ever looked at those lovely glossy cards on store shelves and wished that you could make similar ones

? Well, it's not too difficult. Some basic tools + your imagination = Great cards! Here's how!

Choose the colours you want to use. This example shows use of bronze and white papers for the card. You can vary the colours as per your requirement. Take a more than 160 grams per square meter weight paper (250 gsm paper is used in this example), preferably A4 sheet but you can really use any size you want. Fold it into half and decide which side you want to use as the front of the card .

Make guidelines on the back side of the front cover. In this case, guidelines are made 2.5 cm from the edge, leaving enough room for the design to be accommodated.

Stick the card embosser pattern with scotch tape along the guiding lines. Don't use ordinary cello tape as it's hard to remove. Scotch tape comes off easily - Card Card embosser Machine .

Take an card embosser needle (as you can see in the picture here) and start outlining the pattern on the front cover, much like moving a pen around on a stencil.

Outline the inner pattern after you're through with the outer pattern.

Keeping the edge of the embossed pattern in mind, cut the bronze (or whichever colour you want) paper ribbon and paste it as shown

Make two rectangles with this ribbon.

Paste the second mold on the outside of the front cover (it's a positive card embosser pattern). You can use a negative card embosser pattern also. In that case, you need to paste it on the back side, much like the angel card embosser pattern.

Start card embosser with the needle on the reverse side. This is how it'll look from the back as you emboss.

After you're through with card embosser, cut out the portions from in between and if you wish to, make a thin border cut.

Paste a bronze colour paper at the back to give it a matched look.

Use the same bronze colour paper, cut out flowers and paste them as shown.

Paste a white flower of a smaller size on top of the bronze flower. Using an ordinary paper punch, cut out two small circles of bronze paper and paste them at the centre of the white flower. And that's it - card tipper

. The card is ready.

http://www.cardteq.com

by: cardteq1

POST COMMENT

Make An Angel Card With Card Embosser - Cardteq Achieving all Your Goals in Seven Steps Card Embossing Machine With Card Embosser - Cardteq Attracting Bats Card Embossing Machines Cardteq What Is Card Embosser? - Cardteq Hot Ed Hardy-- Found More Than You Considered Is C. diff Contagious: What Everyone Should Know Grocery Gourmet Store A Revolutionary Store San Bruno, CA Gasoline Explosion How to run best in your 10k run Event Planning How air filters help asthma sufferers