Paper Bag Problem - Green Marble Texture Manufacturer - Seamless Marble Texture Manufacturer

In geometry, the paper bag problem or teabag problem involves calculating the maximum

possible inflated volume of an initially flat sealed rectangular bag which has the same shape as a cushion or pillow, made out of two pieces of material which can bend but not stretch.

The problem is made even more difficult by assuming that the bag is made out of a material like paper or PET film which can neither stretch nor shear.

A cushion filled with stuffing

A numerical simulation of an inflated teabag

According to Anthony C. Robin, an approximate formula for the capacity of a sealed expanded bag is:

where w is the width of the bag (the shorter dimension), h is the height (the longer dimension), and V is the maximum volume.

A very rough approximation to the capacity of a bag that is open at one edge is:

(This latter formula assumes that the corners at the bottom of the bag are linked by a single edge, and that the base of the bag is not a more complex shape such as a lens).

The square teabag

In the special case where the bag is sealed on all edges and is square with unit sides, h = w = 1, and so the first formula estimates a volume for this of roughly:

or roughly 0.19. According to Andrew Kepert at the University of Newcastle, Australia, the upper bound for this version of the teabag problem is 0.217+, and he has made a construction that appears to give a volume of 0.2055+.

In the article referred to above A C Robin also found a more complicated formula for the general paper bag. Whilst this is beyond the scope of a general work, it is of interest to note that for the tea bag case this formula gives 0.2017, unfortunately not within the bounds given by Kepert, but significantly nearer.

References

Weisstein, Eric W., "Paper Bag" from MathWorld.

Baginski, F.; Chen, Q.; and Waldman, I. (2001). "Modeling the Design Shape of a Large Scientific Balloon". Applied Mathematical Modelling 25: 953956. doi:10.1016/S0307-904X(01)00024-5.

Mladenov, I. M. (2001). "On the Geometry of the Mylar Balloon". C. R. Acad. Bulg. Sci. 54: 3944.

Paulsen, W. H. (1994). "What Is the Shape of a Mylar Balloon?". American Mathematical Monthly 101: 953958. doi:10.2307/2975161.

Anthony C Robin (2004). "Paper Bag Problem". Mathematics today, Institute of Mathematics and its Applications June: 104107. ISSN 1361-2042.

External links

The original statement of the teabag problem

Andrew Kepert's work on the teabag problem

Curved folds for the teabag problem

A numerical approach to the teabag problem by Andreas Gammel

MathWorld article

Categories: Geometric shapes | Mathematical optimization

by: gaga

POST COMMENT

Manufacturers Are Measured By Their Ability To React Quickly Methods to help you Choose a Excellent Replica Manufacturer Timepiece Jon Rubinstein - Marble Texture Manufacturer - Coarse-brick Texture Invincible Class Aircraft Carrier - Tdm Over Ip Manufacturer - Tdmoip Manufacturer Pugad Baboy - Core Drilling Rig - Geological Drilling Rig Manufacturer Nhl Uniform - Others Manufacturer - Heat-resistance Fire-proof Cable Mechanical Seals Manufacturers Chris Gaines - Villa Manufacturer - Flexible Truss System Silk - Diode Laser System Manufacturer - 1470nm Diode Laser Module Manufacturer Maheshraj is manufacturer of all these chemicals : PAAB4SA, 6 Nitrio 2 Amino Phenol 4 Sulphonic Acid(6 NAPSA), 4 Palfinger Buys Brazilian Manufacturer Madal Changji Prefecture, Xinjiang Was A Modern Dairy Farming Scale - Tdm Over Ethernet Manufacturer Freetrack - Caustic Soda Pearl Manufacturer - Caustic Soda Solid Manufacturer