Air Conditioning Units in Norman: Troubleshooting Guide Are you looking for some help with air conditioning repair? Given is a brief troubleshooting guide which will come in handy while fixing your air conditioning unit. Air Conditioning Units in Norman: How to Repair Them?
1. Thermostat This is the most neglected and overlooked aspects of air conditioning repair. Check the thermostat if the air conditioner stops working. It is possible that the thermostat might be switched off. Adjust the temperature of the thermostat on the basis of the room temperature. After doing this, ensure that the electrical breaker has not been tripped. Turn off the breaker and switch it on again to make sure that it is working fine.
2. Blower Unit Examine the condition of the blower unit if your air conditioning is not working. The blower unit is situated inside the main air conditioning housing. It is similar in appearance to a hamster-like wheel. Check the following components: 1. heck for damaged blades 2. Check the duct system 3. Examine the filter It is important you clean the filter at least once in two months. Remove the filter and clean it with warm water. Allow the filter to dry before you plug it again. Replace the filter, if it is damaged beyond repair. 3. Check the fan Check if the fan is working appropriately. Spin the fan by hand and see if the blades spin on their own at least for five minutes. If it does not spin properly it means that the bearings are worn out. Replacing the fan motor is the best solution to this problem. 4. Check the Compressor Examine the compressor by opening the air conditioner housing. The compressor resembles a round canister. Replace the refrigerant if the compressor is over-heating. Ensure that you use a refrigerant that does not contain hazardous materials.