An Electric Winch Is A Wise Choice

This method is the epitome of the definition of "brute force." Start by digging around the stump cutting through any roots you come across

. When you are deep enough to get a chain securely around or underneath the stump you connect the other end to a electric winch mounted to another tree or vehicle. An electric power electric winch is a wise choice.

Be extremely careful by making sure everyone is out of the area and that the electric winch operator is well shielded. If the electric winch cable or chain breaks, or if the chain slips off the stump, a deadly catapulted steel whip can result. Any property in range could also be severely damaged including the vehicle.

There are plenty of macho types that might be laughing when they read this however if all these instructions make you a bit weak in the knees, there are plenty of other docile methods for removing stumps.

1. The cover rests upon and is supported by the pool water. Therefore, prior to cover installation, it is important to make sure the pool is not leaking.

2. Follow the pool manufacturer's/builder's winterizing instructions for your pool and accessories.

3. Consult with your pool dealer on the appropriate winterizing chemicals to be used. The pool must be chlorinated until freeze-up to prevent algae growth.

4. Although your winter cover is made of tough material, it is required that you pad sharp corners, abrasive decking, protrusions, rough edges of the coping, etc. with old towels, foam remnants, corrugated cardboard, etc. Also, place padding underneath the electric winch.

5. Lower the water level in your pool below the skimmer and return lines to prevent freezing.

6. Weave cable through grommets all the way around the cover. Insert one end of the cable through the hole at the end of the electric winch and into spindle. Insert the other end of the cable through the hole on the opposite side of the electric winch and into the same spindle. Pull both ends of the cable through as far as possible. Start turning electric winch to tighten the cover. If material bunches or gathers, simply walk around the pool and position neatly.

7. When the cover is installed on the pool, it is normal for a small amount of water to seep onto the surface of the cover.

8. For deck pools, place the cover over the pool with the black side down. Either weave the cable through the grommet and between the pool deck stanchions or run short pieces of cable from the grommet to the individual stanchions.

9. It is important to tie down the cover properly to assure that the cover is not subjected to wind damage.

by: ann00123

POST COMMENT

Aluminum Casting Products pouring temperature Choosing The Best Digital Photo Printers Digital Picture Holder - The Brilliant Trendy Gift Is It Really Difficult To Install Aluminum Fencing? New technology for the Digital signage(Outdoor LCD advertising Display)! Open The Water Heater Is Electric Shower Women Business Lost 120,000 Dead Save Money With An Electric Wall Heater Kazakhstan National Electricity Market Prospects For At Least A Year Increased By 30% Kids Digital Camera: Top Camera Products For Children Plasma Cutter -the Modern Device Types of digital camera battery and battery-keeping the camera Everything You Want To Know About Aluminum Cases For Pcs Gree Air Conditioning Copper Tube Was Secretly Switching? 2 Years 3 Fluorine Leak