For those of you who have in no way set up or labored with a brick property you may possibly want to think about hiring someone to do this for you. It may possibly seem to be like an very easy endeavor but there are a handful of methods that will both make or break your installation. Hiring somebody to set up the bahama shutters for you is substantially cheaper than changing the broken bricks about your windows.
If you are heading to go ahead and attempt to install them your self than make positive you have completely researched how to do this with out breaking the bricks. Like I claimed previous to if you break the bricks you are going to expend two times as a lot having this fixed.
The initial point you are heading to want to do is go down to your neighborhood hardware shop and get the following.
" 2" concrete anchors
" 3 tubes of liquid nails
" 9/16" concrete drill bit
" Hammer drill (hire if you don't currently personal a person)
For every shutter you should certainly use atleast eight concrete anchors. You will be anchoring the aluminum header and the two camel brackets. Every single camel bracket normally takes two anchors which leaves four anchors for your header.
When you do to drill these holes you can't just drill anyplace. There are only specified spots on a property that you can drill lacking bad tasks occurring. For brick or stone households you want to drill into the mortar and the mortar only. If you drill into the brick or the stone it will crack. As soon as it has cracked it will not maintain nearly anything. If you endeavor to place a concrete anchor into it you may well get it to hold for about a week but the to begin with major gust of wind will rip it suitable off your house.
You also don't want to drill too deep into the mortar. The mortar itself is 2" thick. Behind that you will have about 1" of dead room and then particle board. You do not want to drill into the particle board. One good trick to make positive you do this ideal is to measure up 2" on the drill bit and mark it with electrical tape.
As soon as the holes are drilled you really want to fill them with caulking. This will do a couple of tasks for you. First of all it will make certain that your anchors are even additional safe. Second it will seal off the entire so that moisture hardly ever penetrates into the particle board.